HVAC Emergency? Here Is What to Do Right Now

Emergency HVAC

HVAC Emergency? Here Is What to Do Right Now

AC out in 100-degree heat? Heater failed overnight? Here is exactly what to do in the first 30 minutes of an HVAC emergency in Riverside County.

R
Revive Heating & Air Conditioning
••7 min read
HVAC Emergency? Here Is What to Do Right Now

HVAC Emergency? Here Is What to Do Right Now

Your AC stops working at 2 PM on a July afternoon in Menifee. The temperature outside is 107°F. You have kids, elderly family members, or pets in the house.

Or it's January, the temperature dropped overnight, and your heater isn't producing any heat.

These are real emergencies. Here's exactly what to do — step by step — in the first 30 minutes.

First: Don't Panic, But Do Act Quickly

Most HVAC failures have a simple cause that you can check yourself in 5 minutes. Some require a professional immediately. This guide will help you figure out which situation you're in.

If Your AC Stops Working in Summer

Step 1: Check the Thermostat (2 minutes)

This sounds obvious, but it's the most common cause of "AC emergencies" that aren't actually emergencies.

  • Is the thermostat set to COOL (not HEAT or OFF)?
  • Is the setpoint below the current room temperature?
  • Are the batteries dead? (Try replacing them)
  • Is the display blank? (Check the circuit breaker for the air handler)

If the thermostat looks fine, move to Step 2.

Step 2: Check the Circuit Breakers (3 minutes)

Your HVAC system has at least two circuit breakers — one for the air handler (usually labeled "Air Handler" or "Furnace") and one for the outdoor unit (usually labeled "AC" or "Condenser").

Go to your electrical panel and look for any breakers that are in the middle position (tripped) rather than fully ON or fully OFF. A tripped breaker will be slightly out of alignment with the others.

If you find a tripped breaker:

  1. Turn it fully OFF first
  2. Then turn it back ON
  3. Wait 5 minutes and see if the system starts

If the breaker trips again immediately: Stop. Do not keep resetting it. A breaker that keeps tripping is protecting you from an electrical fault. Call a professional.

Step 3: Check the Air Filter (2 minutes)

A severely clogged air filter can cause the evaporator coil to freeze, which stops airflow completely. Pull out your filter and look at it.

If it's gray, clogged, or you can't see light through it — replace it. Then check the indoor unit for ice. If you see ice on the refrigerant lines or the air handler, turn the system to FAN ONLY (not cooling) and let it thaw for 2–4 hours before restarting.

Step 4: Check the Outdoor Unit (2 minutes)

Go outside and look at the condenser unit (the large box with the fan on top).

  • Is the fan spinning? If the fan isn't running but you can hear the compressor humming, the fan motor may have failed.
  • Is the unit completely off and silent? Check the disconnect box next to the unit — there's a pull-out fuse block inside. If it's been pulled or the fuses are blown, the unit won't run.
  • Is the unit covered in ice? This indicates a refrigerant or airflow problem.
  • Is there debris (leaves, dirt) blocking the coil fins? Clear any debris from around the unit.

Do not try to open the electrical compartment of the outdoor unit yourself. High-voltage capacitors inside can hold a lethal charge even when the power is off.

Step 5: Call for Service

If none of the above steps resolved the issue, you need a professional. When you call, tell them:

  • What the system is doing (or not doing)
  • What you already checked
  • Whether you have vulnerable occupants (elderly, infants, medical conditions)
  • The make and model of your system if you know it

Revive's emergency line: (951) 206-4975. We offer same-day service throughout Riverside County.

While You Wait for the Technician: Staying Safe in the Heat

If your AC is out in summer and you're waiting for service, take these steps to keep your household safe:

Immediate Cooling Measures

  • Close blinds and curtains on south and west-facing windows to block direct sun
  • Turn on ceiling fans — they don't cool the air, but the wind chill effect makes it feel 4–6°F cooler
  • Move to the lowest floor — heat rises, so the ground floor or basement will be cooler
  • Use wet towels on pulse points (wrists, neck) for immediate cooling
  • Minimize heat sources — avoid cooking on the stove, turn off unnecessary lights and electronics

Know the Signs of Heat-Related Illness

Heat exhaustion: Heavy sweating, cool/pale/clammy skin, fast/weak pulse, nausea, muscle cramps, tiredness, weakness, dizziness, headache, fainting. Move to a cool location, apply cool wet cloths, sip water.

Heat stroke (medical emergency): High body temperature (103°F+), hot/red/dry skin, rapid/strong pulse, confusion, unconsciousness. Call 911 immediately.

Vulnerable populations: Elderly adults, infants and young children, people with chronic medical conditions, and pets are at highest risk. If you cannot cool your home and have vulnerable occupants, go to a cooling center, library, or air-conditioned business while waiting for repairs.

If Your Heater Stops Working in Winter

Step 1: Check the Thermostat

Same as above — verify it's set to HEAT, the setpoint is above room temperature, and the batteries are good.

Step 2: Check the Circuit Breaker and Gas Supply

For a gas furnace:

  • Check the circuit breaker for the air handler
  • Check that the gas shutoff valve on the gas line to the furnace is open (handle parallel to the pipe = open; perpendicular = closed)
  • Check that your gas service is on (try a gas stove burner)

For a heat pump:

  • Check both circuit breakers (air handler and outdoor unit)

Step 3: Check the Filter

Same as above — a clogged filter can cause a furnace to overheat and shut down on the high-limit safety switch.

Step 4: Look for Error Codes

Modern furnaces have a diagnostic LED that flashes error codes. Look through the small window on the furnace cabinet for a blinking light. Count the flashes and look up the code in the owner's manual or on a label inside the furnace door.

Common codes:

  • Ignition failure: The furnace tried to light but couldn't. Could be a dirty flame sensor, failed igniter, or gas supply issue.
  • High limit: The furnace overheated and shut down. Usually caused by a clogged filter or blocked vents.
  • Pressure switch: A draft inducer or venting issue. Don't attempt to fix this yourself.

Step 5: Call for Service

If the furnace won't start after checking the above, call for service. If you smell gas, leave the house immediately and call SoCalGas at 1-800-427-2200 from outside.

What NOT to Do in an HVAC Emergency

  • Don't keep resetting a tripped breaker. If it trips more than once, there's an electrical fault.
  • Don't try to recharge refrigerant yourself. Refrigerant handling requires EPA certification. DIY refrigerant kits are ineffective and can damage your system.
  • Don't open the electrical compartment of the outdoor unit. Capacitors hold lethal voltage.
  • Don't ignore a gas smell. Leave immediately and call SoCalGas.
  • Don't run a generator indoors or in the garage. Carbon monoxide poisoning kills.

Preventing the Next Emergency

Most HVAC emergencies are preventable with regular maintenance. The components that most commonly cause sudden failures — capacitors, contactors, and fan motors — degrade gradually and can often be identified before they fail completely.

An annual tune-up in spring (before cooling season) and fall (before heating season) catches these issues early, when they're inexpensive to fix rather than emergency repairs in the middle of summer.

Ready to schedule maintenance or need emergency service? Call Revive at (951) 206-4975 or book online. We serve all of Riverside County, 7 days a week.

Need help with your HVAC system? Revive Heating & Air Conditioning offers AC repair throughout Riverside County. Serving Menifee, Murrieta, and Temecula — call (951) 206-4975.

Explore Topics

#HVAC emergency#AC not working#heater failure#Riverside County#emergency repair

Share this article

R

Written by

Revive Heating & Air Conditioning

Revive Heating & Air Conditioning is a family-owned HVAC company serving Riverside County, CA. Licensed (CSLB #1146947) and trusted by homeowners across Menifee, Temecula, Murrieta, and surrounding communities for AC repair, heating, installations, and maintenance.

Get My PriceBook OnlineCall Revive Now