Best AC Temperature Settings to Save Money This Summer
The right thermostat setting can cut your cooling bill by hundreds of dollars a year. Here is exactly what to set — and when — for Riverside County summers.
Best AC Temperature Settings to Save Money This Summer
Your thermostat is one of the most powerful tools you have for controlling your energy bill — and most homeowners are not using it to its full potential. In Riverside County, where summer cooling costs can run $200–$400 a month, the right settings make a real difference.
Here is the practical guide to thermostat settings that keep you comfortable without running up your bill.
The Department of Energy's Recommended Settings
The U.S. Department of Energy recommends:
- 78°F when you are home
- 85°F when you are away
- 82°F when you are sleeping
These numbers are a starting point, not a rule. Many people find 78°F too warm during the day, especially in Inland Empire heat. The key principle is this: every degree you raise the thermostat saves approximately 3% on your cooling costs.
So if you currently keep your home at 72°F all day, raising it to 78°F could cut your cooling bill by roughly 18%. On a $300 summer electric bill, that is $54 a month — over $300 for the season.
The Best Schedule for Riverside County Homes
Here is a practical thermostat schedule that works well for most households in Menifee, Temecula, and Murrieta:
Weekdays (Working Household)
| Time | Setting | Why |
|---|---|---|
| 6:00 AM – 8:00 AM | 76°F | Morning cool-down before the day heats up |
| 8:00 AM – 5:00 PM | 82–85°F | Nobody home — let it warm up |
| 5:00 PM – 10:00 PM | 76–78°F | Family home, comfortable evening |
| 10:00 PM – 6:00 AM | 78–80°F | Sleeping — slightly warmer is fine |
Weekends (Home All Day)
| Time | Setting | Why |
|---|---|---|
| 6:00 AM – 10:00 AM | 76°F | Cooler mornings, lower load |
| 10:00 AM – 6:00 PM | 78°F | Peak heat hours — balance comfort and cost |
| 6:00 PM – 10:00 PM | 76°F | Evening wind-down |
| 10:00 PM – 6:00 AM | 78–80°F | Sleep mode |
Why You Should Never Set Your AC Below 72°F
It is tempting to crank the AC to 68°F when you walk in from a 105°F afternoon. But here is the problem: your AC does not cool faster at a lower setting. It runs at the same speed regardless of the target temperature — it just runs longer.
Setting it to 68°F instead of 76°F means your system runs for hours longer to reach a temperature that is only marginally more comfortable. You pay significantly more for a small gain.
If you want to cool down fast after coming inside, use ceiling fans. They make a room feel 4–6°F cooler without adding to your electric bill.
Smart Thermostats: Worth It in Riverside County
A programmable or smart thermostat pays for itself quickly in a hot climate. Here is what they do that manual thermostats cannot:
Automatic scheduling — Set it once and forget it. The thermostat raises the temperature when you leave and cools back down before you return.
Learning algorithms — Smart thermostats like the Ecobee or Nest learn your patterns and optimize automatically. Some models integrate with utility rate schedules to pre-cool your home during off-peak hours when electricity is cheaper.
Remote control — Stuck in traffic? Adjust your home temperature from your phone so it is comfortable when you walk in.
Energy reports — See exactly how much your AC is running and where your costs are going.
In Riverside County, where cooling season runs nearly 8 months, a $150–$250 smart thermostat typically pays for itself in the first year.
The Pre-Cooling Strategy for Hot Afternoons
One of the most effective strategies for Inland Empire summers: pre-cool your home in the morning.
Electricity rates are typically lower before noon. If you cool your home to 74°F by 10 AM, the thermal mass of your walls, floors, and furniture holds that coolness for hours. Your AC does not have to work as hard during the 2–6 PM peak heat window.
This is especially effective in well-insulated homes. Combined with blackout curtains on west-facing windows (which take the brunt of afternoon sun), pre-cooling can significantly reduce how hard your system works during the hottest part of the day.
When Your AC Cannot Keep Up With the Thermostat Setting
If your AC is running constantly but cannot reach your set temperature on a hot day, that is a different problem — and it is not solved by adjusting the thermostat.
Common causes include:
- Dirty air filter — Restricts airflow and reduces cooling capacity. Check and replace it first.
- Low refrigerant — A leak causes the system to lose cooling power gradually.
- Dirty evaporator or condenser coils — Reduces heat transfer efficiency.
- Undersized system — If the system was never properly sized for your home, it will always struggle on extreme heat days.
- Duct leaks — Cooled air escaping into your attic before it reaches your rooms.
If your system is running all day and your home is still 5–10°F above your set temperature, call a technician. Running a struggling system harder does not fix the underlying problem — it just accelerates wear.
Quick Tips to Help Your AC Work Less
- Use ceiling fans — They allow you to raise the thermostat 4°F without feeling warmer.
- Close blinds on south and west windows during peak afternoon hours.
- Run heat-generating appliances (oven, dishwasher, dryer) in the evening or early morning.
- Seal air leaks around doors and windows to keep cool air in.
- Schedule annual maintenance — A clean, tuned system runs more efficiently and costs less to operate.
At Revive Heating & Air Conditioning, we help Riverside County homeowners get the most out of their HVAC systems. Whether you need a tune-up, a smart thermostat installation, or a full system check, we are here.
Call or text (951) 206-4975 for same-day service across Menifee, Temecula, Murrieta, and surrounding areas.
Revive Heating & Air Conditioning is a family-owned HVAC company based in Menifee, CA. CSLB License #1146947.
Need help with your HVAC system? Revive Heating & Air Conditioning offers HVAC maintenance throughout Riverside County. Serving Menifee, Murrieta, and Temecula — call (951) 206-4975.
Explore Topics
Share this article
Written by
Revive Heating & Air Conditioning
Revive Heating & Air Conditioning is a family-owned HVAC company serving Riverside County, CA. Licensed (CSLB #1146947) and trusted by homeowners across Menifee, Temecula, Murrieta, and surrounding communities for AC repair, heating, installations, and maintenance.